The autoclave is a heat treating chamber which applies pressure and high temperature to a material in order to cure it. The pattern may also be called octahedral.Īutoclave: A pressurized heating device used for shaft construction. This pattern was the predominant pattern prior to the 1970’s. This creates 8 triangular groupings of dimples on the ball. Small triangular arrays of dimples fill the remaining area on the ball.
This is the opposite of how normal clubs today are made.Īttihedral: Pattern of dimples on a ball comprised of four straight rows of dimples around the middle of the ball, with four around each pole. More modern clubs that were anti-shank were sold by the Jerry Barber company in the 70’s and even more recently by Cleveland Golf in their VAS models of irons in the 90’s.Īppendix II (Design of Clubs): United States Golf Association (U.S.G.A.) Rule Book section dealing specifically with regulations for the design of golf clubs.Īscending Weight Technology: The concept of utilizing lighter shafts in the long irons of a set for added club head speed and distance, while using heavier shafts in the shorter irons to promote control.
They may also be known as aluminum alloy heads.Īnti-Shank: General term given to older hickory shafted golf clubs that had large bends or offsets in their hosels to eliminate shanked shots. They typically are not as durable as stainless steel woods and do not possess high coefficient of restitution (spring face) properties. Aluminum woods are generally utilized by beginning players due to their lower price. They did not gain lasting popularity due to their feel (as a result of their thicker walls as compared to steel shafts which changed the bending properties) and due to them being less durable than steel shafts.Īluminum Wood Head: A type of metal wood head constructed primarily from aluminum alloys through a die casting process. Also known as aluminum oxide sand.Īluminum Shafts: Golf shafts formed from aluminum tubing, used primarily in the 1960’s and early 70’s. Alloys may contain aluminum, steel, beryllium, nickel, copper, titanium, or any number of other metals in varying combinations.Īluminum Bronze: Head material used for wedges and putters that is a softer metal than stainless steel identified by a bronze color but not to be confused with beryllium copper.Īluminum Oxide: Media used in sandblasting applications of metal wood heads and iron faces.
Also known as a hex wrench because it has five sides.Īlloys: A metal that is made up of two or more different metals.
Wilson fat shaft iron chart install#
May also be known a hex screw or set screw.Īllen Wrench: Type of wrench used to install or remove Allen screws. See “Crimp.”Īllen Screw: Threaded screw used in weight ports. Air hammers are typically used in production line settings in which the manufacturer also crimps the shafts prior to installation to create a tighter shaft fit.
Acetone actually melts plastic.Īermet: Patented high strength steel made by Carpenter Steel used primarily as a face material for large-volume stainless steel drivers.Īir Hammer: Mechanical device, typically run by an air compressor that forces a shaft into a head using impact hammering. Acetone is rubbed onto the ferrule with a rag or towel in order to obtain the luster. Also referred to as a tip weak shaft.Īcetone: Chemical used to bring ferrules to a high luster as a final step in assembly. Abrading may be done through the use of sandpaper, a belt sander, a file, a knife, etc.Īccelerated Tip Response: Golf shaft technology, pioneered by UST, in which the tip of the shaft is more flexible than the rest of the shaft, creating a softer feel and potentially higher trajectory. The process of removing the chrome finish from a steel shaft or the layer of paint from a graphite shaft prior to installation of the shaft into the head. Abrade: To roughen the surface of a golf shaft so the epoxy will adhere better to the head.
0 kommentar(er)
